Welcome!

This community is for professionals and enthusiasts of our products and services. Share and discuss the best content and new marketing ideas, build your professional profile and become a better marketer together.

0

Using the SR Sound Template

By
Carlton Guc
on 10/24/16, 3:09 PM 352 views

Video: Introduction of the Sound Template

Download PDF version of this document.

  • Contains the specs on over forty of over the most commonly used speakers.

  • Gives you the tools to predict the SPL of a speaker with just a pencil and paper.

  • Brings the information you need together in one place for those production meetings.

  • The Sound Design Drafting Template is a great teaching tool for explaining basic sound theory.

Every Speaker in the main section has two cut-outs. The top is the “Top View”. The bottom is the “Side or Front/Back View”. The name is below the cut-outs. This symbol ((- indicates the grill of the speaker. If you do not see one of these on the bottom cut-out it means the cut-out is the “Front/Back”. Most of the time they are the same size, when they are not you will see a on the top and bottom. This indicates the size of the smaller view of the speaker. The pattern is above the “Top View”. It is written as Horizontal x Vertical. It has the Weight and Dimensions between the two cut-outs. On the side are the specs for the speaker. This will help you plan out the needed amps as well as research paper help predict what the speaker will do. These specs use abbreviations which are: A=AVERAGE C=CONTINUOUS P=PEAK R=ROTATABLE S=SENSITIVITY.


 

This is a specialized protractor to help you draw the pattern of the speakers. Once you use a cut-out to draw a speaker you will use this to draw the pattern. Ex: You draw a CQ-1 where a center cluster would go on a ground plan. Then you draw the pattern to see where the speaker will hit. To do this you place the hole at the focal center of the speaker. Line up the straight edge to be parallel with grill of the speaker. Then select the degree of the pattern and mark it. Rotate the template and do the same for the other side of the speaker. You then use the straight edge scale to draw the pattern as far as you need it to go.




COMPASS HOLES

 


Compass Holes are on the line at the top. These can be used to finish drawing the cone of the speaker. Simply place the “0” hole on the focal center of the speaker. Hold it down using a pencil. Using a second pencil pick a hole a certain distance from the focal center and rotate the template to draw an arc.

dB






The information on the bottom left edge will help you predict the dB. For example: An SSM has a Sensitivity of 88.8dB, which is 1 Watt at 1 Meter. It calls for a 150 Watt amp. This would give you an added 22dB making the speaker 110.8db at 1 meter. And at 8 meters it would be 92.8dB.

SPL





Using the Inverse Square Law information on the top left edge of the template in conjunction with the speaker specs you should be able to predict the SPL at any distance from the speaker.




Add a Comment

Keep Informed

About This Community

This community is for professionals and enthusiasts of our products and services. Read Guidelines

Question tools

1 follower(s)

Stats

Asked: 10/24/16, 3:09 PM
Seen: 352 times
Last updated: 10/24/16, 3:22 PM